Question

Firmware, rom or flash file downloading and flashing for  the Prestigio MultiPad PMT3037 3G or PMT3038 3G with the MT6582 chipsets. See the answer area below for both directions on obtaining the link and tips on flashing this Prestigio tablet model through the SP Tool. The board ID ELINK-MR706Z-V3

Comments

Hi,
Can i use this firmware on swag tab which same board id ELINK-MR706Z-V3

---

File did not work when it was tested on the Swag 703 but we have a file specific for that model here: https://www.saroms.co.za/product/swag-expert-703-tablet-firmwarerom/

Answer 1

For the ROM, go here: http://roms.satechhelp.co.za/product/prestigio-pmt3037pmt3038-3g-tablet-firmwarerom/ and refer below for flashing instructions.

1. First download and install/extract the following: SP Flash Tool
2. Also download and extract the Prestigio MultiPad PMT3037 3G or PMT3038 3G firmware or ROM from
3. Install the MediaTek Preloader USB VCOM drivers as per the tutorial here
4. Launch the SP Tool from the extracted folder
5. Click 'Scatter-Loading' > browse to and locate the MT6582 .txt scatter file from your extracted firmware or ROM folder files
6. Make sure 'Preloader' NOT ticked :) - untick it if already ticked
7. Then click on the Download button
8. Connect the Prestigio MultiPad PMT3037 3G or PMT3038 3G to the computer via a compatible USB cable while holding the Vol Up/Down key (release as soon as connection is established) so computer can detect and connect to its system
9. The flashing process should then start with progress bars (red being the first) and you should get a green cycle with a white tick and the text 'Download OK' when the flashing is completed. At which stage you can safely disconnect the your Prestigio MultiPad PMT3037 3G or PMT3038 3G device and power it on for a re-setup.

NOTE: We can flash the device for you remotely (over the internet) for R100 If you are not comfortable flashing the device yourself. Read more here