Question

i already download this firmware Mecer 800P31C tablet Firmware/ROM (MT6582) but when i flash it with sp flash tool it does not download i also have many different tool like cstool inferno cm2 but this firmware donsnt work here is my complete info for tab            Action : Read Info


 Phone found [ USB Port:COM61 ]
 Connecting...
 Connection Done.
 Read CPU Info...
 CPU_ID: 6582
 CPU_SW: 0001
 CPU_HW: CA01
 uploading boot image to RAM...
 Handshake received from Phone.
 Detected eMMC FlashType.
 uploading boot image to RAM...
 Handshake Received from Phone.
 eMMC cid: 700100563130303038
 CHIP     : MT65820000
 CPU ID   :
 EMMC ID  : 700100563130303038
 EMMC Size: 8GB,  usable capacity: 7.05GB
 EMMC Name: eMMC_Kingston_V10008
 Boot Information completed.

Answer 1

Hey - It is a tested ROM though. You say you tried to hold a boot key prior to establishing connection? Also, what is the issue with tab - have tested you run a Memory Test?

Comments

my issue is tab is stuck on meccer logo it dosnt on i alredy check hardware is fine i have 3 tab same cpu this firmware dosnt work....

---

But SP Flash Tool failing to start is usually a non-ROM issue. SP Flash Tool will either give an error on the go or flash but not boot. A non-start should not be a ROM issue. While some have been able to flash the Mobicel Candy with no issue, some reports non-start cases. While I am not certain of the exact possible cause of this, I am made to believe that it then must be a driver, PC, SP Flash Tool verssion related issue rather than the ROM which is tested.